FUTABA RADIO CONTROL 8FGS(H ) WITH R6208SB RECEIVER F24W2HX220 CHARGER AND BATTERIES

Futaba 8FG(H) Super 2.4GHz 14-Channel Radio System for airplane, heli, glider
                   with the R6208SB Receiver and No Servos.
    

FEATURES: Futaba's FASST (Futaba Advanced Spread Spectrum Technology) shifts
            very quickly virtually eliminating signal conficts and
            interruptions unlike other 2.4GHz systems that only stay on one or
            two frequencies
          Fourteen total transmitter channels, 12 proportional and 2 switched
          20-model memory expandable to unlimited model setups and downloads of
            online software updates with a 32MG - 2GB SD memory card (memory
            card not included)
          R6208SB receiver accepts a wide range of batteries, from 4-cell NiCd
            and NiMH packs to 2S LiFe and LiPo packs with no regulator required
          Receiver is capable of controlling up to eight channels using the
            outputs for a conventional system and up to eighteen channels
            including the two digital channels by using the output for the
            S.BUS system, receiver also has a high-speed mode that delivers
            ultra fast frame rates on channels 1-6
          Ten character model and user name
          SensorTouch programming
          Backlit 128x64 LCD screen
          Factory defined mixes
          Stick calibration menus
          Trainer system (must purchase Trainer Cord)
         

INCLUDES: T8FGHS Transmitter
          R6208SB Receiver, 
          HT6F1700B 1700mAh NiMH Transmitter Battery,
          HBC-2B(4) Battery Charger, 
          Switch Harness
          Neck Strap
          Instruction Manual

REQUIRES: Servos
          Receiver battery, size and mAh rating dependent on aircraft and
            number of servos used

SPECS:      Transmitter;
          Transmitting Frequency: 2.4GHz band
          Modulation: 2.4GHz 7ch or 2.4G multi-channel switchable
          Power Supply: 7.2V HT6F1700B NiMH Battery
            R6208SB Receiver;
          Power Requirement: 3.7 - 7.4V battery or regulated output from ESC*
          Size: 0.98 x 1.86 x 0.56" (24.9 x 47.3 x 14.3mm)
          Weight: 0.49oz (13.8g)