Your shopping cart is empty!
MENU
INSTA-CURE+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA-CURE+ ™ should also be used. To prevent premature curing, don’t spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread the CA out.
Works Best On: Balsa Wood, Soft Wood, Hard Wood, Glass & Metal, Fiberglass, Carbon, Ceramics, Hard Plastics, Rubber
Water-Resistant, Bonding time 5-15sec.
Remove or clean with acetone or BSI 161 un-cure debonder
1oz. Bottle
+30 2106834783
Phone Support
WORKING HOURS
Mon - Wed - Sat : 9:00 - 15:00
Tues - Thur - Frid : 9:00 - 14:00 & 17:00 - 20:00
RETURNS
Refunds are made within 10 days
